THE IMPLEMENTATION OF A PROGRAMMED CONTROL SYSTEM FOR THE TRANSPORTATION OF RAW MATERIALS IN A FNC

Authors

  • Cristian Vasile Represents the Department of Terrestrial Measurements, Management, Mechanization from the Faculty of Agriculture and Horticulture, Craiova

Abstract

Within the technological flow in a FNC are taking place several highly complex processes which should be very carefully monitored in order to obtain diversified recipes and continuous improvement of the products quality. One of the most important activities in a FNC is the transportation of raw materials between the different workstations.
This article presents the possibilities of implementing automatic control equipment for the transport activities which are taking place in a FNC by designing some devices based on electronic contactors which allow the operators to transmit switching start or stop signals to the engines which control the horizontal conveyor belts and the vertical elevators in case of detecting problems in their normal rhythm of functioning, so that any possible losses of raw materials to be maximum limited. [7,8]

Downloads

Published

2014-09-03

Issue

Section

Working Group 4: Management, agriculture mechanization and cadastre